Mechanical Edge Finder pack of 1 size:10x4 Non Magnetic Golden coated but 50 mm and 63

but 50 mm and 63 mm cutters are usually standard in this range

The alignment cone slides in an outer cup which squares the whole assembly to the workpiece when pressed down on the template

brown coatedSUITABLE TO ALL MILLING CUTTERS FOR APMT1604

Endmill for Better Life and wear resistance

also called a touch point sensor

Mechanical Edge Finder pack of 1 size:10x4 Non Magnetic Golden coated but 50 mm and 63Mechanical Edge Finder, also called a touch point sensor, is used to determine the workpiece's zero point and the centre of the hole. T TYPE Disc diameter is 28 mm, and the rod attached is 9 mm, holding dia is 10 mm, ceramic edge finder for magnetic component, as ceramic is non magnetic Edge Finder Mechanical is used for a range of tasks. This one is Non Magnetic.