Custom Pommel Section 001 [for Clan saber series] diy I recommend a minimum of

I recommend a minimum of 25% infill to give it a good weight

Simple chassis printed in PLA-Carbon Fiber

For EK/AG and MW/KF hilts

They have the same thread as most of our knobs from the clan series M8x0

This is an empty hilt but can be installed and uses a 7/8" blade and a 28mm speaker

Custom Pommel Section 001 [for Clan saber series] diy I recommend a minimum ofThis is a custom pommel made out of a series 1 body and a special series 2 end nut. It comes with an Oring. There are 3 versions: Sand blasted with polished nut and the all polished. All polished All polished with Bronze anodized aluminum body Note: These parts are compatible with the other Clan Saber Series. You can mix and match sections to create custom saber designs.